IBM Power System Series Manual page 97

Temple's zeppelin procedures for install, remove, replace
Hide thumbs Also See for Power System Series:
Table of Contents

Advertisement

Figure 71: Partially sliding the system from the rack
5. Remove the service access cover by completing the following.
Attention: Operating the system without the cover for more than 10 minutes might damage
the system components. For proper cooling and airflow, replace the cover before turning on
the system.
a. Push the release latches (A) in the direction shown in the following figure.
b. Slide the cover (B) off the system unit as shown in the following figure. When the front of the
service access cover has cleared the upper frame ledge, lift the cover up and off the system unit.
SAS cables in the 9040-MR9 93

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Power system e950 9040-mr9

Table of Contents