IBM Power System Series Manual page 111
Temple's zeppelin procedures for install, remove, replace
Hide thumbs
Also See for Power System Series:
- Handbook (336 pages) ,
- Manual (245 pages) ,
- Problem analysis, system parts, and locations (134 pages)
Table of Contents
Advertisement
Figure 85: Replacing the SAS cable holder
7. Replace the service access cover.
a) Lower the cover (A) onto the system unit. Ensure that the cover alignment pins (C) on each side of
the cover fit into the matching slots in the chassis.
b) Slide the cover (A) onto the system unit.
c) Close the release latches (B) by pushing it in the direction that is shown in the following figure.
SAS cables in the 9040-MR9 107
Hide quick links:
Advertisement
Table of Contents
