Table of Contents
Advertisement
Installation manual
7. Once all fault conditions have been cleared, turn the key in the keyswitch to access Level 2 (refer to
paragraph 2.4 Operator classification - Access Levels) then press RESET. The display will show:
Figure 30 - Message on display on first startup
8. Press the TEST button to check the integrity of the LEDs.
Powering up the system
SmartLoop In Service
No Alarm
No Fault
11/11/11 06:23 Fri
41
- Quick Links:
- Maintenance
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SmartLoop Series and is the answer not in the manual?