Forced Lowering Switch - Valtra 6000 Workshop Manual

FORCED LOWERING SWITCH,

FITTING INSTRUCTION
Forced lowering switch
--- When this switch is depressed, the working depth
adjustment is overridden and an implement low-
erst quickly into ground (according to the lowering
speed switch position). When the switch is
released, the lower links find the position deter-
mined by the position control potentiometer.
FITTING INSTRUCTION:
--- Remove the lever console side panel.
Remove the upper panels (2 pcs) and unscrew the
lever console cover panel securing screws.
--- Remove auxiliary valve lever knob symbol lenses
and unscrew the knob securing screws. Remove
the knobs and remove the lever protective rubbers.
Remove the knob of the PTO control lever.
Disconnect the connectors and remove the cover
panel.
--- Make a hole through the cover panel for switch 6,
according to the picture so that the forced lowering
switch and the lift/lower switch (S10E) are as near
each other as possible.
File the end edges of the switch opening a little
thinner so that the switch is kept in position. (point
A). Fit the switch.
--- Connect the wire loom connector 3 to the position
control potentiometer. Connect connector 2 to
switch 6
Connect the wire loom wires no 5 (no 15 and earth)
to the bulp of the lift/lower switch.
--- Fit the upper panel and the cover panels into posi-
tion. Connect connectors. Connect connector 4 to
the cab wire loom connector "R1E".
Connect the lift/lower switch wires (no 15 and
earth) back to the connectors of the lift/lower
switch illumination wires.
--- Test the function of the switch. The forced lowering
switch functions only when the lift/lower switch is in
the lowering position.
. . . . . . . . . . . . 33009700
20.02.1995
567
Code
Model
6000---8400 39
Page
1(2)