Direction Indicator Flashers; Indication Light For Glowing; Charging Light; Hour Recorder And Rev Counter - Valtra 6000 Workshop Manual

33. Agroline ---instrument
6. Others
A. Direction indicator flashers
There are three indicator lights in the instrument:
--- tractor flashers
--- first trailer flashers
--- second trailer flashers
The indicator lights flash simultaneously with the flasher
lamps. If e.g. one of the trailer lamps is blown, the indica-
tion light in question does not flash in the dashboard.
The flasher relay K10 is placed separately in front of the
fuse box.
B. Indication light for glowing
This light is lit when the ignition switch is turned to the glow-
ing position (THERM), at which time the glow plug in the
engine intake manifold is energised and warms up engine
intake air.
C. Charging light
This light is on, when the ignition is switched on, but the
engine is not running. After the engine has started the light
must go out.
If this light comes on while driving, check the alternator
wires and the alternator.
D. DPS indication lights (not HiTech)
These lights are in Mezzo/Mega ---tractors, which have the
AC 2.3 system. In HiTech ---models the DPS speed is shown
in the AC 5---display on the RH side front pillar of the cab,
see page 370/4.
Concerning function of these indication lights, see AC 2.3
pages 314/4 ---5.
Model
6200-- 8950Hi
1. 9. 2002
E. Σ---light in 8950Hi.
When the higher output range of the engine is engaged,
there is a light Σ in the warning light panel.
This light also works as a fault diagnostic light informing by
flashing (with different frequencies) of a possible fault (sen-
sor is out of order/cable is broken). Warning light gets the
signals from the Σ ---Power unit.
SigmaPower ---basic functions in Agroline are the same as
in Agrodata ---instrument (see page 313/1).
Agroline ---instrument can show in 8950Hi ---model, how
many percent of the max PTO power is transmitted via the
rear PTO, when the PTO is engaged.
F. Hour recorder and rev counter
The analog engine revs counter (equipped with a hand)
receives signals fron the alternator pin W. The Agroline ---in-
strument digital hour recorder gets the signals from the
alternator pole W.
In case of problems, check the alternator wires and alterna-
tor.
G. Position of lower links
Agroline ---instrument can monitor the position of the lower
links (AC) between digits 0 ---100. This function is both in
ACB and ACD power lifts. The function is the same as
earlier in the Agrodata ---instrument.
The display shows symbol AC and the position of the lower
links as a percentage scale 0 --- 100. 0 = the lower links
are in the lowest position and 100 = the lower links are in
the top position. When the lower links are in the middle
position, the display shows the number 50.
115
Code Page
333
11