Checking Dbc/Slip Control Selector S12E; Checking Lift/Lower Switch S10E - Valtra 6000 Workshop Manual

32. ACD electro---hydraulic power lift

5. Checking DBC/slip control selector S12E

Picture e) Measure voltage between pin 8 and pins 1
(DBC) and 2 (slip control) with all selector positions:
Position Pin 1
OFF 4,5 ---5,2 V
DBC 0
DBC+slip control 0
Slip control 4,5---5,2 V
Note! If the measured values in points 2 ---5 deviate from
the given values, the fault lies in the switch panel circuit
card which should be changed.

6. Checking lift/lower switch S10E

Picture f. Measure voltage between pin 8 and 9 in all
rocker switch positions:
Position Pin 9
Lowering position 3,0 ---3,4 V
Middle position 4,3---4,8 V
Transport position 6,0---6,6 V
Note! If the measured values deviate from the given values,
check the switch connector. If the values are further incor-
rect, the fault lies in the circuit card which should be
changed.
Pin 2
0
0
4,5---5,2 V
4.5---5,2 V
98
Model
1. 11. 1998
8450-- 8750
1. 9. 2002
Code Page
321 8