Functional Differences Of Program Versions, Comparison, Ac 5 Only - Valtra 6000 Workshop Manual

37. Autocontrol 5
F. Functional differences of program versions, comparison, AC 5 only
HiTech ---PROGRAMS
DIFFERENCES BETWEEN MAIN PROGRAM VERSIONS:
VERSION 41
Parking brake is not connected to AC5 –control
unit.
Five different parameter files for all PTO types (in
production and in service).
PTO rocker switch in the cab.
Seat indicator delay is 4 seconds.
Parking brake can be applied under
speed of 4 km/h .
VERSION 41
Pre ---programmed DPS ---speeds engages:
--- when driver moves shuttle lever to F --- or R ---
position (without clutch pedal)
--- or when driver presses the HiShift ---button
(with or without shuttle lever)
The DPS ---pre ---programming and AutoDPS can be
engaged simultaneously => unnecessary gear
shifts in the driving direction change.
When AutoDPS is in function, the use of the DPS
push buttons can disturb the gear change when
stopping driving.
PTO symbol is visible in AC5 –display, when the
PTO shaft rotates over 45 r/min.
1. 10. 1999
1. 9. 2002
VERSIONS 42, 43, 50, 52, 60, 62
** GENERAL **
Reverse drive controls can be fitted as an option.
PTO start ---/stop push buttons can be fitted in rear mudguards
(option).
AC5 –unit controls the parking brake.
** AC5 ---PROGRAMS **
Five different parameter files in tractor production.
Only two different parameter files are needed in service (PTO ratios
can be set with indexes).
** FUNCTIONS **
PTO rocker switch in cab and push button in rear mudguards (op-
tion). Operating instructions, see Operator's Manual.
Seat indicator delay is 6 seconds.
Parking brake can be applied under speed of 2 km/h (4 km/h in ver-
sions 50 and 52).
VERSIONS 42, 43, 50, 52, 60, 62
Pre ---programmed DPS ---speeds engages:
--- when driver moves the shuttle lever to F --- or R --- position (with
or without the clutch pedal)
--- or when driver moves the shuttle lever to F --- or R --- position and
simultaneously presses the HiShift---button (the gear is engaged
after the button is released)
When AutoDPS is in function, the DPS ---pre ---programmed speeds
are by ---passed temporarily. The pre ---programmed speeds are
activated, when AutoDPS is disengaged.
When the tractor is stopped, AutoDPS engages always gear no. 1
although the DPS push buttons are pressed simultaneously.
AutoDPS gear shift delay has been shortened. Also some points in
gear shift diagrams have been modified.
PTO symbol is visible in AC5 –display, when the PTO shaft rotates
over 150 r/min.
126
Model Code
370
6250-- 8950
Page
9C