Troubleshooting - PerkinElmer Lambda 365 Installation Instructions Manual

Troubleshooting

W hen the M ulti-Cell does not m ove
1. Check with the connector port.
Check if the Changer 8-Cell for Dissolution connector is connected firmly to the Lambda 365.

W hen the intensity value is low
1. Recalibrate the Multi-Cell.
Recalibrate if the light beam does not go through the center of the cell holder.

2. Replace the lamp.
If the intensity value is still low after the recalibration, the lamps of the light source for

measurement may be deteriorated and need replacing. Contact PerkinElmer for replacing the
lamp.
W hen the M ulti-Cell does not reset
If resetting fail, the photo interrupter switch inside the Multi-Cell will need replacing. Contact your
PerkinElmer Service representative.
18
09931465A