PerkinElmer Lambda 365 Installation Instructions Manual page 8

7. Tighten the Changer 8-Cell for Dissolution in the sample compartment with the screws. (The red
circles indicate the location of the screws in the figure).
Figure 17. Tighten the Changer 8-Cell for Dissolution
8. Attach the plate for calibration on the front plate and tighten the 4 bolts.
Figure 18. Tighten the 4 bolts
9. Close the sample compartment cover and turn on the power switch of the instruments.
Do not start the UV Express software before finishing the initialization of grating.
CAUTION
Ne dém arrez pas le logiciel UV Express avant de terminer l'initialisation du
ATTENTION
réseau.
8
09931465A