PerkinElmer Lambda 365 Installation Instructions Manual

Test tube holder

Hide thumbs Also See for Lambda 365:

Download this manual

This instruction sheet describes the installation of this accessory which is used with the Lambda 365

Spectrophotometer.

Read these instructions before you install this accessory.

NOTE:

Contacting P erk inElm er

Supplies, replacement parts, and accessories can be ordered directly from PerkinElmer, using the part

numbers.

See our website:

http://perkinelmer.com

PerkinElmer's catalog service offers a full selection of high-quality supplies.

To place an order for supplies and many replacement parts, request a free catalog, or ask for information:

If you are located within the U.S., call toll free 1-800-762-4000, 8 a.m. to 8 p.m. EST. Your order will be

shipped promptly, usually within 24 hours.

If you are located outside of the U.S., call your local PerkinElmer sales or service office.

Features

• Available with various tube cells

• Excellent durability

Figure 1 Lambda 365 Test Tube Holder [P/N: N4101018]

Lam bda 365 Test Tube Holder

I nstallation I nstructions

09931258D

PerkinElmer, 710 Bridgeport Avenue,

Shelton, CT 06484-4794, U.S.A

Produced in the USA.

Page 1 09931258D Lam bda 365 Test Tube Holder I nstallation I nstructions This instruction sheet describes the installation of this accessory which is used with the Lambda 365 Spectrophotometer. Read these instructions before you install this accessory. NOTE: Contacting P erk inElm er Supplies, replacement parts, and accessories can be ordered directly from PerkinElmer, using the part numbers.
Page 2: Dimensions And Specifications
Sample Size (mm) Min~Max. Diameter: 10~20 Configuration of the Test Tube Holder Figure 2 Lambda 365 Test Tube Holder Configuration Figure 3 Height adjustment plate (2 ea) and Phillips round head screw with washer (M3x8L, 4 ea) Figure 4 Knob...
Page 3: Installation
09931258D I nstallation 1. Loosen the knob to take apart the existing cell holder. Figure 5 Loosening the knob 2. Pull out the cell holder by hand. Figure 6 Pulling out the cell holder 3. Insert the test tube holder in the sample compartment and tighten the knob. Figure 7 Inserting the test tube holder...
Page 4 09931258D 4. Turn on the power switch which is located on the rear of the instrument. 5. Insert the tube in the test tube holder. Figure 8 Inserting the test tube holder...
Page 5 09931258D Sam pling W hen the tube height is less than 105 m m 1. Insert the tube in the test tube holder. Figure 9 Inserting the test tube W hen the tube height is m ore than 105 m m Available tube height up to 130 mm.
Page 6 09931258D...