PerkinElmer Lambda 465 Installation Instructions Manual

Lam bda 465 Fiber Optic Probe I nstallation I nstructions
This instruction sheet describes the installation of this accessory which is used with the Lambda 465
Spectrophotometer.
NOTE: Read these instructions before you install this accessory.
Contacting P erk inElm er
Supplies, replacement parts, and accessories can be ordered directly from PerkinElmer, using the part
numbers.
See our website:
http://perkinelmer.com
PerkinElmer's catalog service offers a full selection of high-quality supplies.
To place an order for supplies and many replacement parts, request a free catalog, or ask for information:
If you are located within the U.S., call toll free 1-800-762-4002, 8 a.m. to 8 p.m. EST. Your order will be
shipped promptly, usually within 24 hours.
If you are located outside of the U.S., call your local PerkinElmer sales or service office.
I ntroduction
The probes provide a convenient way of performing absorption or transmission measurements by dipping
or inserting the probe end into the medium or environment. This accessory is especially useful for
embedding into process streams for real-time, on-line sample monitoring.
Features
• Easy to install
• Dip Probe for measuring liquid samples without using a cell
Figure 1 Lambda 465 Fiber Optic Probe [P/N: N4104012]
with Fiber Optic Probe [Part No: N4101048]
09931297D
PerkinElmer, 710 Bridgeport Avenue,
Shelton, CT 06484-4794, U.S.A
Produced in the USA.