Cli Commands; Add Community; Add Dns - Black Box 16 port User Manual

CLI commands

add community

user level: This command enables you to define up to four SNMP communities.
admin
Syntax
a d d c o m m u n i t y c o mm u n i ty _n a me i ne t ad dr es s
n on e | r ea do nl y | r ea d wr it e
Where:
community_name is an arbitrary name assigned to the community.
inetaddress
none | readonly |
readwrite
See also
add trap,

add DNS

user level: This command enables you to define the DNS (Domain Name Service) host or hosts
admin in your network. You can enter the addresses two DNS hosts in the unit; one will be
referred to as the primary host, the other a secondary host. The DNS hosts do not
have to be the same hosts as entered in your unit's host table.
On a remote access connection the unit will transmit these addresses to a dial-up
Windows NT/95 client. Therefore, your remote user does not have to configure DNS
parameters in his/her computer.
For more information on DNS see
Syntax
a d d D N S i n te rn et _a d dr es s
Note 'DNS' must be entered in upper case. Also:
internet address is the internet address of your machine providing the DNS; enter
Black Box Console Server user guide
is the internet address that identifies the host(s) in the community.
defines the access permission for the community.
delete community, set contact,
the address in dot decimal notation.
set location, show snmp
DNS configuration on page 56.
142