Selecting Aui Or 10/100 Base T Interface - Black Box 16 port User Manual

Selecting AUI or 10/100 Base T interface

Before performing the initial configuration of your Console Server unit, you need to
select the type of interface you want to use from either AUI or 10/100Base-T
(Default setting is 10/100Base-T). To do this proceed as follows;
Note To display the currently selected interface type, at the command prompt, type
show hardware and press the Enter key. The resulting display will include the
currently selected hardware type.
You only need to use these commands on revision 2 Console Server boards.
1. Login to your unit and display the command prompt.
2. At the command prompt, type one of the commands listed in the next table to
select the interface type you want to use.
You can now perform the initial configuration of the unit.
Black Box Console Server user guide
To set this type of interface
10/100Base-T
AUI
Use this command
set ethernet interface RJ45
set ethernet interface AUI
32