Jetset Problems - Black Box 16 port User Manual

Access to host lost after a few minutes
•If the route to this host goes through routers, make sure those routers are all
You see a message saying your host is in use.
•delete your host as either, a DNS or WINS host, or a gateway, then retry the
The connection fails when the user 'ip_host' parameter is set to 0.0.0.0
other factors: several hosts are entered in the unit's host table
•check the host ip address entered in the server configuration; it is this ip address

JETset problems

Trying to access JETSET you see an 'alert' dialog box, e.g. :
•change the parameter 'gui_access' to 'on'.
Black Box Console Server user guide
sending RIP packets across the networks.
'delete host' command/menu item. You may have configured your host as
a DNS or WINS host, or a gateway.
- and not hosts in the host table - which the unit will use when a user's
ip_host is set to 0.0.0.0
254