Emergency Recovery; Problems With Framed Routing - Black Box 16 port User Manual

Emergency recovery

Problem:
You have a unit already configured and,
- you do know your password, but
- have lost, misconfigured or don't know the IP address of the unit, and
- you cannot obtain a login on any port (including the console port)
The emergency recovery method is to use BOOTP (see
•Setup a host machine on your network to run BOOTP. Using the ethernet
•Now, you should be able to telnet into the unit and change its IP address.
Using BOOTP to recover access to your unit in this manner will preserve all
configuration settings - apart from the IP address.

Problems with framed Routing

Problem:
Check:
Problem:
Check:
Problem:
Check:
Black Box Console Server user guide
address of the unit (printed on the base of the product) BOOTP will assign
the unit a known IP address.
My SLIP/PPP link is running but I am not seeing any routing
information propagated to my dial up clients.
Make sure that SLIP/PPP links are configured for route broadcasts,
see section 9.1.
Wait for 30 seconds before checking again for new routes, routes are
broadcast every 30 seconds.
I can talk to my dial-up clients, but not any other machine on the
network it is attached to.
Make sure that your dial-up client is configured to pass on RIP (
routing ) packets to it's other network interfaces. This may involve
installing additional routing software on some operating systems.
I have configured framed routing for a SLIP/PPP link but routing does
not work.
Both Remote IP Address and Local IP Address need to be configured
with valid IP addresses for framed routing to remote clients to operate.
Appendix F BOOTP).
258