Table of Contents
Advertisement
Troubleshooting
Checking Fault Codes (EH Models Only)
If the Diagnostic LED indicates that there is a system fault (refer to
(page
17)), check the fault codes to determine what is wrong with the machine.
Entering Diagnostic Mode and Checking the Codes
1.
Push the E-S
TOP
2.
Pull the tethered cap from the 2 diagnostic shunt connectors
3.
Connect the diagnostic shunt connectors together
4.
Pull the E-
up to turn on the power.
STOP
5.
Count the number of flashes to determine the fault code, then consult the following table:
Note:
If there are multiple faults, both faults will flash, then a long pause, then the flash sequences
will repeat.
button down to turn off the power.
Diagnostic LED Function (EH Model 44954)
(Figure
(Figure
63B).
Figure 63
55
63A).
g028876
Advertisement
Table of Contents
