Safety Checks - Toro MH-400SH2 Operator's Manual

Material handler, serial no. 401252001 and up
Hide thumbs Also See for MH-400SH2:
Table of Contents

Advertisement

Figure 53
Figure 54
Figure 55
g014131

Safety Checks

At the start of each day, complete these safety
checks before operating the machine. Report any
safety problems to your supervisor. See the Safety
Instructions in this manual for details.
Note:
Photocopy these pages and use them as a
regular safety checklist
Tires and Wheels
The recommended tire pressure is 172 kPa (25
g014132
psi) for 84 cm (33 inch) tires and 207 kPa (30 psi)
for 81 cm (32 inch) tires, or as recommended by
the tire manufacturer.
Check for excessive wear or visible damage.
Check that the wheel bolts are tight and none are
missing.
Rear Gate
Check that the rear gate closes and latches
securely.
Check that the adjustable section of the rear gate
opens and closes without sticking.
Hitch, Jack, and Rear Jack Leg
Check that the hitch pin and jacks are not
damaged, and the safety pins are in place.
g014133
(Replace missing or damaged safety pins.)
Check that the hitch connections are not loose. (If
so, install a spacer between the hitch connections.)
Safely stow all jacks in the up position before
traveling.
47
Figure 56
g014134

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mh-400eh24493144954

Table of Contents