Table of Contents
Advertisement
1. Mirror
4
Wiring and Installing to the
Tow Vehicle
Parts needed for this procedure:
1
Foot controller
1
Brake controller
1
Harness assembly
1
Socket bracket
4
Screw (5/16 x 1 inch)
4
Nut (5/16 inch)
6
Wire splices
10
Cable tie
2
Bolt (#10 x 7/8 inch)
2
Nut (#10)
1
Hose clamp
Outcross Traction Unit
Mount the brake controller
area of the dashboard with the 2 bolts (#10 x 7/8 inch)
and nuts (#10).
Figure 7
(Figure
8) to the lower left
Connect the Outcross wire harness connector to the
brake controller connector.
Refer to the Outcross traction unit Operator's Manual
for additional mounting and operating instructions.
g015149
1. Brake controller
Tractor
Note:
Lay out the harness on the tractor to determine
the mounting locations of the harness components.
Cable ties are supplied to retain any surplus cable
lengths. Also, wire splices are provided if the length
of the harness has to be altered (shortened or
lengthened). Heat the shrink connectors until they
shrink tight onto the wires.
Important:
If length is added to the harness,
make sure to use the proper gauge wire.
1.
Mount the socket bracket to the rear of the tow
vehicle with 2 bolts (5/16 x 1 inch) and nuts.
2.
Route the wire harness connector through the
hole to the socket. Slide the boot down the
harness if the connector does not go through
the hole.
3.
Bolt the wire harness, with the socket connector,
to the rear of the socket bracket with 2 bolts
(5/16 x 1 inch) and nuts.
4.
Route the harness along the tow vehicle.
5.
Mount the brake controller to the tractor dash or
the fender with the 2 bolts (#10 x 7/8 inch) and
nuts (#10).
6.
Using the hose clamp, secure the foot controller
to the pad on the tow vehicle brake pedal.
7.
Connect the harness to the components
9) as follows:
12
Figure 8
g235379
(Figure
Advertisement
Table of Contents
