Required Hardware
Comcode/Code
Description
108312612
TN2302AP IP Media Processor (MedPro)
848525887
TN2302AP Amphenol Adapter
1
The adapter has an amphenol connector on one side and an RJ45 connector on the other for
connecting to the network. See
NOTE:
The customer must provide one CAT5 or better cable for each TN2302AP.
Install a TN2302AP IP Media Processor
The TN2302AP consumes 16 watts of power and the power budget is 15 watts per slot. Do not
fill every available slot in a given media gateway (G600 or SCC1) or carrier (MCC1) with
them. Use the following guidelines:
•
MCC1—18 per carrier
SCC1—16 per media gateway
•
•
G600—5 per media gateway
Have the following equipment on site before your shipment arrives:
An unoccupied port slot in the media gateway for each TN2302AP IP Media Processor
•
A 10 BaseT or 10/100 BaseT Ethernet connection into your local area network (LAN).
•
•
One or more valid, unused IP addresses on the network that can be assigned to the IP
Media Processor server. You also need the subnet mask and default gateway.
NOTE:
Get this information from the network administrator or refer to the job aid entitled
Pre-Installation Network Planning Form—S8700 Media Server.
In addition to the TN2302AP IP Media Processor, you must also install and administer a
C-LAN circuit pack (TN799DP). For C-LAN installation and administration, refer to
''TN799DP Control LAN'' on page
Install the cables
1
Determine into which port slots you are putting the TN2302AP IP Media Processor
circuit packs.
From the rear of the media gateway:
2
Connect the amphenol connector on the adapter to the Amphenol connector
corresponding to each TN2302AP slot. Refer to
page
224.
1
''TN2302AP Amphenol Adapter'' on page
216.
''TN2302AP Amphenol Adapter'' on
October 2002
Connecting to the Customer's Network
Quantity
1or more
1/MedPro
224.
223