Avaya S8700 Installing Manual page 104

104
Installing an Avaya SCC1 Media Gateway Stack
7 At the rear of the media gateway, remove the two hole plugs from the bottom of the
media gateway. See
104.
8 Insert a pencil or marker through the holes in the bottom of the media gateway and mark
the floor directly beneath each hole.
9 Move the media gateway out of the way and drill a hole 0.5-inch (1.27 cm) in diameter
and 1.5 inches (3.8 cm) deep at the locations marked in Step 10.
10 Insert a concrete floor anchor (STARR part number 3425) into each hole.
Move the media gateway back into place and align with the Front Mounting Angle.
11
Attach the media gateway to the Front Mounting Angle using the four supplied #12-24 x
12
1/2-inch (1.27 cm) thread-forming screws. See
page
13 Lay the supplied Stiffener on the bottom rear of the media gateway and align with the
holes in the bottom of the media gateway. See
— Rear View'' on page
14 Slide a nylon washer onto each of the two supplied long hex head bolts.
Insert the bolts through the Stiffener and thread into the concrete floor anchor. Tighten
15
securely.
Media Gateway Earthquake Mounting — Rear View
''Media Gateway Earthquake Mounting — Rear View'' on page
105.
104.
1
On On
Off Off
2
3
5
8
7
October 2002
''Front Mounting Angle Location'' on
''Media Gateway Earthquake Mounting
4
6
r781851a CJL 030796