Using Static Addressing - Avaya S8700 Installing Manual

208
Connect the Hardware
6 All segments of the display will go dark for one second and then the Switch ID and
Cabinet number will be displayed in the top three characters of the LED display. A 'V'
will be shown in the fourth character (bottom) of the display. When an address has been
assigned to the IPSI by the DHCP server, the center of the 'V' will be filled in to form the
bottom half of a diamond in the display.
For high or critical reliability configuration, repeat steps 1 through 6 for the IPSI in
7
carrier B.
8 Press excess ribbon against the circuit packs.

Using static addressing

For the IPSI circuit packs to get static IP addresses, you must administer them directly through
the Ethernet port connection on the IPSI faceplate (top port). See
IPSI'' on page 209.
October 2002
CLK
S
E
R
V
''Connecting directly to the