212
Connect the Hardware
Enable control of IPserver interfaces
NOTE:
The next procedure will enable the IPSI circuit packs and allow them to control the port
networks.
1
Type change system-parameters ipserver-interface and press
change system-parameters ipserver-interface
SERVER INFORMATION
OPTIONS
Set the IPSI Control of Port Networks field to: enabled
2
3
Press
Verify License Status
The following administration is done on a computer used to access the active media server
using the media server web interface.
1
Under Security click View License Status and verify that the license mode is now
normal.
Connect the USB Modems
!
WARNING:
Once the modems are cabled to the servers, do not unplug the modem USB cable on the
active server. If modems must be changed, do it on the standby server.
Required options in the modems will be set by the operating system on the server. There are no
options to set on the modems themselves.
Co-located servers
Both servers share one telephone line.
•
Verify the firmware release for each TN2312AP IPSI. If upgrade is required go to
Upgrade tab above to upgrade the IPSI firmware.
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
IPSI Host Name Prefix: vodka
Primary Control Subnet Address: 198.152.254.
Secondary Control Subnet Address: 198.152.255.
Switch Identifier: A
IPSI Control of Port Networks: enabled
to effect the change.
Enter
October 2002
.
Enter
Page
1 of
0
0
1