Set Product Id - Avaya S8700 Installing Manual

Configure Media Server 1
You must configure each media server in turn. This section covers the following tasks:
• ''Connect and log into the S8700 media server Web Interface'' on page 28
• ''Verify Software Version'' on page 30
''Set media server configuration type'' on page 31
•
• ''Continue Server 1 configuration'' on page 33
''Install License and Avaya Authentication Files'' on page 37
•
''Verify Media Server 1 Connection to Customer's LAN (if provided)'' on page 38
•
• ''Test Media Server 1 LEDs'' on page 40
''Configure SNMP Traps'' on page 41
•
The following administration uses the services laptop computer and the media server Web
interface. Connect the services laptop computer to the dedicated services port (default is port 2
[Eth1]) on the back of the media servers using the black crossover cable.
NOTE:
Make sure you have the filled-out job aid entitled Pre-Installation Network Planning
Forms-S8700 Media Server before beginning this process.
NOTE:
Make sure your networking and Web browser settings are correct. Refer to the job aid
entitled Pre-Installation Information-S8700 Media
Power up media server 1
1 Plug the AC power cord for media server 1 into UPS 1 to power it up. Refer to
Started with the Avaya™ S8700 Media Server with MCC1 or SCC1 Media
Gateway.

Set product ID

You must assign a product ID number to the configuration. You can obtain this product ID
number from the Automatic Registration Tool (ART) script.
1 Click Start > Run to open the Run dialog box
Type telnet 192.11.13.6 and press
2
3 Log in as craft.
At the prompt type
4
Log off.
5
.
Enter
productid -p and press
number
October 2002
Configure Media Server 1
Server.
.
Enter
27
Getting