Seat Toledo 2014 Owner's Manual page 233

– Lightly press the defective bulb into the bulb holder, then turn it
anti-clockwise and remove it.
– Fit the new bulb, pressing it into the bulb holder and turn it
clockwise as far as it will go.
– Use a cloth to remove any fingerprints from the glass part of the
bulb.
– Check that the new bulb works properly.
– Re-install the bulb holder ⇒ p age 231.
– Screw in the bulb holder.
Number of bulbs
Pos.
Bulb function
⇒ F ig. 170
Reverse light
A
Side lights
B
Fog lights
C
Note
One of the two sides might not be fitted with a fog light, depending on the
country and type of driving. In this case, the hole for the light is covered.
Fitting the bulb holder
The bulb holder is easy to fit.
– Position the bulb holder on the tail light and align it so that it is
securely seated.
Safety First
P21W
R5W LL
P21W
Operating instructions
– Screw in the bulb holder using the corresponding screw.
– Make sure the connector is correctly in place.
– Close the inner trim cover.
Note
Check the condition of the seal. If damaged, a replacement can be acquired
from an Official Service.

Practical Tips
Fuses and bulbs

Technical specifications
231