Seat Toledo 2014 Owner's Manual page 188

186 Checking and refilling levels
Checking the engine oil level
The dipstick shows the engine oil level.
Checking oil level
– Park the vehicle on a level surface and ensure the engine is at
operating temperature.
– Switch the ignition off.
– Open the bonnet.
– Wait a few minutes for the engine oil to flow back to the sump
and remove the dipstick.
– Wipe the dipstick with a clean cloth and insert it again as far as
it will go.
– Then pull the dipstick out again and check the oil level.
Fig. 125 Engine oil dip-
sticks
⇒ F ig.
125.
Oil level in area
A
– Do not top up oil.
Oil level in area
B
– Oil can be topped up. After topping up the oil level could be in
area .
A
Oil level in area
C
– Oil must be topped up. After topping up the oil level should be
in area .
B
It is normal for the engine to consume a certain amount of oil. Depending
on how you drive and the conditions in which the vehicle is used, oil con-
sumption can be up to 0.5 litres per 1000 km (621 miles). Oil consumption
can also be higher for the first 5000 km (3000 miles).
You should therefore check the oil level at regular intervals, ideally every
time you fill the tank or before setting off on a long trip.
When the engine is working hard, for instance during sustained motorway
cruising in summer, when towing a trailer or caravan or climbing on moun-
tain passes, the oil level should preferably be kept within area
higher.
A warning lamp will appear on the instrument panel ⇒ p age 71, Engine oil
 if the oil level is too low. In this case, check the oil level as soon as pos-
sible. Top up with the required amount of oil.
CAUTION
● The oil level must never exceed area
the exhaust system!
● If the engine oil cannot be topped up under the given conditions,  do
not drive on! Stop the engine and seek the professional assistance of an Of-
ficial Service, as this could cause serious damage to the engine.
, but no
A
⇒ F ig.
125. Risk of damage to
A
