Seat Toledo 2014 Owner's Manual page 102

100 Lights and visibility
Note
Make sure you set the range of the main lights when the dipped beam
headlights are switched on.
Turn signal and main beam lever
The turn signal and main beam headlight lever also operates the
parking lights and the headlight flasher.
Right  and left-hand  turn signal
⇒ F ig. 57
– Move the lever
– In order for the turn signals to flash three times (turn signal to
change lanes), move the lever briefly up or down just as far as
point of resistance and then release it.
– Keep the lever held down at the point of resistance for the turn
signals to flash for as long as you hold the lever, e.g. when
changing lanes.
Fig. 57 Turn signal and
main beam headlight lev-
er
up or down .
A B
Mean beams 
– Switch on the dipped beam ⇒ p age 97.

⇒ F ig. 57
– Press the lever
arrow .
C
– Pull the lever back to its original position in the direction indica-
ted by arrow to switch the main beam off.
D
Headlight flasher 
⇒ F ig. 57
– Pull the lever
sistance) in the direction indicated by arrow
Parking lights 
Instructions for use ⇒ p age 101.
CAUTION
Never use the main beam headlights or the headlight flasher if they could
dazzle other drivers.
Note
● The turn signals only work when the ignition is switched on. The corre-
sponding warning lamp  or  flashes in the general instrument panel.
● The turn signals switch off automatically when the steering wheel is re-
turned to the straight-ahead position.
● If a turn signal bulb is defective, the control lamp flashes at double
speed.
forwards in the direction indicated by
towards the steering wheel (point of re-
.
D
