Seat Toledo 2014 Owner's Manual page 99

Lights and visibility
Lights
Introduction
The location of the controls of right-hand drive cars differs slightly from the
⇒ F ig. 54
location shown here
ing the respective positions of the controls remain the same.
WARNING
Never drive with only the side lights on! The side lights are not bright
enough to illuminate the road ahead and to ensure that other road users
are able to see you. Always use your dipped beam headlights if it is dark
or if visibility is poor.
CAUTION
● Use the lights in line with local law.
● However, drivers always remain responsible for correctly adjusting and
using the lights.
Note
● An audible warning will be heard when the light control is set to  and
you remove the ignition key and open the door. Once the driver door is
closed (ignition off), the audible warning will stop, whereas the side lights
will remain on to light up the stationary vehicle if necessary.
● Depending on weather conditions (cold or wet), the lights may mist up
temporarily on the inside. This is particularly the case in the event of a dif-
ference in temperature between the inside and in front of the light. By
switching on the lights, the area through which the beam of light is projec-
Safety First
⇒ p age 97. However, the symbols indicat-
Operating instructions
ted will quickly be demisted, although the edges may remain misted. The
real lights and turn signals can mist up. This has no influence on the useful
life of the lighting system.
Switching lights on and off
Switching on side lights
⇒ F ig. 54
– Turn the light switch
Switching on dipped beam
⇒ F ig. 54
– Turn the light switch
Switching off lights (except daytime driving lights)
⇒ F ig. 54
– Turn the light switch
Practical Tips
Lights and visibility
Fig. 54 Instrument pan-
el: Light switch
to position .
to position .
to position 0.
Technical specifications
97

