Seat Toledo 2014 Owner's Manual page 155

Setting speed
Setting speed
⇒ F ig. 109
– Move knob
A
– Briefly press rocker switch
reached the speed you wish to set.
On releasing rocker switch
remain constant without having to press the accelerator pedal.
Adjusting set speed
Increasing speed by pressing the accelerator pedal
– Press the accelerator to increase the speed of the vehicle.
– Release the accelerator and the previously programmed speed
will be resumed.
If, when pressing the accelerator, the vehicle exceeds the program-
med speed by more than 10 km/h (6 mph) for more than 3 mi-
Safety First
Fig. 109 Turn signal and
main beam headlight lev-
er: cruise control buttons
to the ON position.
in SET position when you have
B
in SET, the current speed is stored and will
B
Operating instructions
nutes, the set speed will be deleted. The speed will have to be
stored again.
Increasing speed by pressing switch
⇒ F ig. 109
– Press rocker switch
B
– If the button is held down in RES, the speed increases continu-
ously. Release the switch when the required speed is reached.
The speed is stored.
Setting a lower speed
– The set speed can be reduced by pressing switch
⇒ p age 153 in SET.
– If the button is held down in SET, the speed lowers continuous-
ly. Release the switch when the required speed is reached. The
speed is stored.
– On releasing the switch at speeds of less than 30 km/h (19
mph), no speed will be set and the memory will be deleted. The
vehicle must be moving at a speed of over 30 km/h (10 mph)

and press switch again in SET for it to be set.
B
The speed can be reduced by pressing the brake pedal, which tem-
porarily switches off the cruise control.
Switching off cruise control temporarily
Cruise control is switched off temporarily by pressing switch
⇒ p age 153 in CANCEL or by pressing the brake or clutch pedal.
The set speed is stored.
Practical Tips
Driving
.
B
⇒ p age 153 in RES.
⇒ F ig. 109
B

⇒ F ig. 109
A

Technical specifications
153