Removing The Lens; Connecting To Ac Power - Christie Crimson Series Installation And Setup Manual

• Damage to the projector.
Calibrate the lens motors when any of the following conditions are met:
• After a lens change.
• After the projector is moved and/or jostled.
• After any manual adjustment is made to the zoom or focus.
To calibrate the lens:
1. Select MENU > Configuration > Lens Settings > Lens Calibration.
2. Select Enter.

Removing the lens

Complete the following procedure to remove the lens.
1. Remove and retain the two security screws (for installation) from the lens mount.
2. Rotate the lens clamp counter-clockwise to the open position.
3. Pull the lens straight out of the lens mount.

Connecting to AC power

The Crimson projectors can operate in full or limited power modes, depending on the available or
required AC power source.
Power mode
Input 1: Full power
Input 2: Limited power
Crimson Installation and Setup Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102647-07 Rev. 1 (12-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Functionality
• 20 amp rated connector IEC 320-C20
• 200 - 240 VAC
• Full brightness
• 15 amp rated connector IEC 320-C14
• 100 - 240 VAC
• Less brightness
Installation and setup
24