Optimizing The Integrator Focus And Zoom - Christie Crimson Series Installation And Setup Manual

10. If further action is required, repeat steps 2 to 9.
11. Lock the setscrews, and re-check the boresight quality.
Tighten the setscrews to 2.1 Nm (18 in-lb) to ensure they do not shift.

Optimizing the Integrator Focus and Zoom

Extreme misalignment of projection optics can cause permanent damage to critical optical
components. Only Christie qualified technicians can perform internal optical adjustments.
1. From the Test Pattern menu, select the Integrator Rod test pattern.
The Integrator Rod test pattern includes guided information for integrator zoom and focus
adjustments.
2. Set the projector brightness level to approximately 50% to 60%.
3. Retrieve the 3 mm hex driver located inside the toolbox.
4. To open the Service door on the side of the projector, loosen the two captive screws.
5. Loosen the Rotate and Focus lockscrew located next to the adjustment slider.
6. Loosen the integrator magnification Zoom lockscrew located next to the adjustment slider.
7. Move both adjustments to the nominal position before optimizing.
Crimson Installation and Setup Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102647-07 Rev. 1 (12-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
31