Leveling The Projector - Christie Crimson Series Installation And Setup Manual

may have to forfeit some aim and stay more perpendicular to the screen. In such cases, some
lens offset can reduce the keystone distortion.
2. Center the projector with the screen.

Leveling the projector

Use the projector feet to level the projector.
1. To adjust the vertical position of the projector, extend or retract the adjustable feet on the
bottom of the projector using the adjustable knobs on the feet.
2. Once the required adjustment is made, using a wrench, tighten the lock nut against the
bottom of the projector.
Notice. If not avoided, the following could result in property damage.
• Always use a lens plug when installing or moving the product. This prevents contaminants from
entering the product.
• Do not insert the lens into the product at an angle. This can damage the lens and the optical
components inside the product.
• Always place the lens cap onto the lens when moving the projector to avoid scratching the lens.
• Remove the lens cap before turning the product on to avoid damaging the lens.
1. Ensure the lens cap is on the lens.
2. Rotate the lens clamp to the open position.
Crimson Installation and Setup Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102647-07 Rev. 1 (12-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
22