Calibrating The Lens Motor - Christie Crimson Series Installation And Setup Manual

Hide thumbs Also See for Crimson Series:

Table of Contents

3. Align the lens interface plate with the lens mount and align the lens electrical connector with

the mating connector on the lens mount.

4. Fully insert the assembly straight into the lens mount opening without turning and press with

your hand as shown.

5. To lock the lens assembly in place, while holding the lens flat against the lens mount, push the

lens clamp down.

6. Remove the front lens cap.

7. For added stability and safety such as motion applications, or if the projector is hoisted or

installed in an overhead position, use a 5mm hex driver to fasten the security screws provided

with the lens mount or hand tighten the lens retaining screws attached to the lens.

Christie recommends doing this for all lenses.

Calibrating the lens motor

Ensure the lens motor is calibrated before using the projector.

If the lens motors are not calibrated properly, implications may include:

•

Incorrect reporting of the lens motor position.

•

Inability to use the full range of the lens motors.

•

Lens motors traveling outside of the pre-defined keep-out area.

Crimson Installation and Setup Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25

020-102647-07 Rev. 1 (12-2019)

Installation and setup

Table of Contents