Christie Crimson Series Installation And Setup Manual page 30

Hide thumbs Also See for Crimson Series:

Table of Contents

6. To fine tune cross-hair pattern II, adjust the appropriate adjustment screw until the cross-hair

image is in focus with minimal flare.

7. To fine tune cross-hair pattern III, adjust the appropriate adjustment screw until the cross-

hair image is in focus with minimal flare.

8. Repeat step 5 to 7 as required until all three cross-hair patterns are in equal sharp focus.

•

If the boresight is acceptable, proceed with step 11.

•

If the boresight does not appear to be converging to an acceptable level of image quality,

or if the lens does not focus over the correct range of throw distances, proceed with step

9. To approximately recover the original factory boresight, position the three setscrews flush with

the front face of the lens mount plate and in contact with the inner lens mount plate.

This may require adjusting both setscrews and adjustment screws.

Crimson Installation and Setup Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25

020-102647-07 Rev. 1 (12-2019)

Installation and setup

Table of Contents