Epub_Prc_All_Memcrds Isolation Procedure - IBM Power System Series Problem Analysis, System Parts, And Locations

Table 11. EPUB_PRC_ALL_PROCS service actions
System
5104-22C or 9006-22C
9006-12P
9006-22P

EPUB_PRC_ALL_MEMCRDS isolation procedure

A problem was detected with a memory DIMM, but it cannot be isolated to a specific memory DIMM.
Procedure
1. Use the ipmitool command to examine system event logs (SELs).
• To list SELs by using an in-band network, use the following command:
ipmitool sel elist
Service action
Replace the following items, one at a time, in the
order that is shown until the problem is resolved:
1. System processor CPU 1
2. System processor CPU 2
3. System backplane
Go to "5104-22C or 9006-22C locations" on page
63 to identify the physical location and removal
and replacement procedure. If the replacement of
the system processors and the system backplane
does not resolve the problem, go to "Contacting
IBM service and support" on page 61. This ends
the procedure.
Replace the following items, one at a time, in the
order that is shown until the problem is resolved:
1. System processor CPU 1
2. System processor CPU 2
3. System backplane
Go to "9006-12P locations" on page 75 to
identify the physical location and removal and
replacement procedure. If the replacement of the
system processors and the system backplane does
not resolve the problem, go to "Contacting IBM
service and support" on page 61. This ends the
procedure.
Replace the following items, one at a time, in the
order that is shown until the problem is resolved:
1. System processor CPU 1
2. System processor CPU 2
3. System backplane
Go to "9006-22P locations" on page 91 to
identify the physical location and removal and
replacement procedure. If the replacement of the
system processors and the system backplane does
not resolve the problem, go to "Contacting IBM
service and support" on page 61. This ends the
procedure.
Beginning troubleshooting and problem analysis 51