Identifying A Service Action By Using Sensor And Event Information - IBM Power System Series Problem Analysis, System Parts, And Locations

• Transition to Non-recoverable
• Predictive Failure
Processor service action keywords
• IERR
• Transition to Non-recoverable
• Predictive Failure
• Device Disabled
Power supply service action keywords
• Power Supply Failure Detected
• Predictive Failure
• Power Supply Input Lost or AC DC
• Power Supply Input Lost Or Out of Range
• Power Supply Input Out of Range But Present
System event service action keywords
• Undetermined system hardware failure
Watchdog service action keywords
• Hard Reset
• Power Down
• Power Cycle
• Timer Interrupt

Identifying a service action by using sensor and event information

You can use sensor and event information from the system event log (SEL) to determine a service action.
Identifying a service action by using sensor and event information for the 5104-22C, 9006-12P,
9006-22C, or 9006-22P
You can use the sensor and event information from the system event log to determine a service action to
perform for the 5104-22C, 9006-12P, 9006-22C, or 9006-22P.
Procedure
If you have not done so already, complete "Identifying a service action by using system event logs" on
page 18. Then, use the following table to determine the service action to perform.
24 Power Systems: Problem analysis, system parts, and locations for the 5104-22C, 9006-12P, 9006-22C, and
9006-22P