IBM Power System Series Problem Analysis, System Parts, And Locations page 36

If
Yes:
No:
12. The OEM record c0 specific log information is indicated by the rightmost digits of the SEL with the
value OEM record c0. Use Table 9 on page 22 to determine the service action to perform.
Table 9. OEM record c0 specific log information, description, and service action
OEM record c0 specific log
information
2aff6ffxxxxx
cdxx6fffffff
ceff6fffffff
cfff6fffffff
13. One or more SEL events might require a service action. These events require a service action if they
meet the following criteria:
• A service action keyword is present. For a list of service action keywords, see "Identifying service
action keywords in system event logs" on page 23.
• Asserted is in the description.
• OEM record is not in the description.
14. Did you find one or more SEL events that require a service action as defined in step "13" on page 22?
If
Yes:
No:
15. The service actions for all of the events that were identified in step "13" on page 22 must be
performed to successfully complete the repair. Record the SEL record IDs for the events that you
22 Power Systems: Problem analysis, system parts, and locations for the 5104-22C, 9006-12P, 9006-22C, and
9006-22P
Then
Continue with the next step.
Go to step "13" on page 22.
Description
A session audit event occurred
An automatic shutdown event
occurred due to high system
temperature
A machine check event
occurred
An unexpected problem
occurred with the voltage
regulator output
Then
Continue with the next step.
This ends the procedure.
Service action
No service action is required.
• Search for SEL events that are
related to high system
temperature and resolve
them.
• Ensure that the room
temperature meets the
requirements that are
specified for the system.
• Ensure that there are no air
flow obstructions at the front
or at the rear of the system.
Search for serviceable SEL
events and resolve them.
If a machine check event is
present with a time stamp close
to the time stamp of this event,
search for serviceable SEL
events and resolve them. If a
machine check event is not
present with a time stamp close
to the time stamp of this event,
reboot the system to recover
from the system hang. If the
problem persists, replace the
system backplane.