Installing The Processing Unit - Kongsberg EM 712 Maintenance Manual

Kongsberg EM 712 Maintenance Manual

Installing the Processing Unit

The Processing Unit is designed to be installed in a 19" rack.
Prerequisites
You must be equipped with a standard set of tools. This
tool set must comprise the normal tools for electronic
and electromechanical tasks. This includes different
screwdriver types, pliers, spanners, a cable stripper, a soldering iron, etc. Each tool
must be provided in various sizes. We recommend that all tools are demagnetized to
protect your equipment.
Context
Refer to the detailed information in the Cable layout and interconnections chapter.
Procedure
1 Grab a firm hold of the unit, and push it straight in.
2 Fasten the unit by securing the mounting bolts on both sides.
3 Connect the power cable on the rear side of the unit.
4 Connect the cables.
Note
When you connect the cables, make sure that they are all properly secured, and able
to withstand the vibration and movements of the vessel.
Further requirements
Once the unit has been installed, follow the normal procedure to turn on the EM 712.
48
451106/B