List Of Em 712 Cables - Kongsberg EM 712 Maintenance Manual

Kongsberg EM 712 Maintenance Manual

List of EM 712 cables

A set of cables is required to connect the EM 712 units to each other, and to the relevant
power source(s).
The following cables are used when the EM 712 is set up.
Cable Signal
C1 Display cable
This is a commercial cable. It is normally provided with the display.
C3
Computer cable
This is a commercial cable. It is normally provided with the keyboard.
C4 Computer cable
C5 AC power cable
C7 AC power cable
C8 Ground cable
C10 Ethernet cable
A 4.5 meter long Ethernet cable is provided with the Processing Unit. If a longer cable is
required, this must be provided by the installation shipyard.
C14 Serial cable
C15 Serial cable
C18 Ethernet cable
C19
Ethernet cable
C25 AC power cable
C26 Ground cable
164
From/To
From Hydrographic Work
Station to display
From Hydrographic Work
Station to keyboard
From Hydrographic Work
Station to mouse (or another
similar device)
This is a commercial cable. It
is normally provided with the
mouse.
From display to AC power outlet
From Hydrographic Work
Station to AC power outlet
From Hydrographic Work
Station to vessel ground
From Hydrographic Work
Station to Processing Unit
From Hydrographic Work
Station to external device(s)
From Hydrographic Work
Station to external device(s)
From Hydrographic Work
Station to external device(s)
From Hydrographic Work
Station to external device(s)
From Processing Unit to AC
power outlet
From Processing Unit to vessel
ground
Minimum requirements
CAT5-E STP (Shielded Twisted
Pair)
451106/B