Kongsberg EM 712 Maintenance Manual page 167

Cable Signal
TX2-1 Transducer cable
-
-
The transducer cables are moulded to the transducer modules and connect in the other end
-
to the Transmitter Unit (TXU) or Receiver Unit (RXU) with connectors.
TX2-10
TX3-1 Transducer cable
-
-
The transducer cables are moulded to the transducer modules and connect in the other end
-
to the Transmitter Unit (TXU) or Receiver Unit (RXU) with connectors.
TX3-10
TX4-1
Transducer cable
-
-
The transducer cables are moulded to the transducer modules and connect in the other end
-
to the Transmitter Unit (TXU) or Receiver Unit (RXU) with connectors.
TX4-10
RX1–1 Transducer cable
RX1–2
RX1–3
The transducer cables are moulded to the transducer modules and connect in the other end
RX1–4
to the Transmitter Unit (TXU) or Receiver Unit (RXU) with connectors.
RX2–1 Transducer cable
RX2–2
RX2–3
The transducer cables are moulded to the transducer modules and connect in the other end
RX2–4
to the Transmitter Unit (TXU) or Receiver Unit (RXU) with connectors.
The standard length of the transducer cables is 15 metres. There is an option for cable
length of 25 metres.
The length of the cables are fixed. The cables can not be extended or shortened during
installation.
Identifying EM 712 cables on a project cable drawing
The EM 712 is often a part of a project delivery. For such deliveries, specific project
cable drawings are established to show all the main cables, and how the various products
are connected. In such project cable drawings, the EM 712 cables may be identified
as .
EM 712/Cx
451106/B
From/To
From Transmitter Unit to
transducer
From Transmitter Unit to
transducer
From Transmitter Unit to
transducer
From Receiver Unit to
transducer
From Receiver Unit to
transducer
Cable layout and interconnections
Minimum requirements
167