Energetics XT 1090 Series Manual page 10

Step 3
HANDLE BAR ASSEMBLY
1. Install the 2pcs of Ø25 Wave Washers (102) onto the Handle Bars (10,11) axle.
2. Slide the Left and Right Handle Bars (10,11) onto the appropriate side of the axle.
3. Put the 2pcs of 3/8"×30×2.0T Flat Washers (131) onto the 2pcs of 3/8"×3/4" Hex Head Bolts (76) and
install, and tighten by using the 13/14m/m Wrench (124) in the threaded holes in the ends of the axle.
4. Install the Front Handle Bar Cover (L)(68) and Rear Handle Bar Cover (L)(68~1) onto the Handle Bar
(L)(10) with the 4pcs ofØ3.5x12m/m Sheet Metal Screws (107) by using the Phillips Head Screw Driver
(126).
5. Install the Front Handle Bar Cover (R)(69) and Rear Handle Bar Cover (R)(69~1) onto the Handle Bar
(R)(11) with the 4pcs of Ø3.5x12m/m Sheet Metal Screws (107) by using the Phillips Head Screw Driver
(126).
10