Table 1-4 Attributes Of The Aux Port; Table 1-5 Attributes Of The Ge Electrical Interfaces - H3C SecPath V1000-A Installation Manual

Installation Manual
H3C SecPath V1000-A Security Gateway
Attribute
Services
II. Auxiliary port (AUX)

Table 1-4 Attributes of the AUX port

Connector
Standard
Baud rate
Services
III. Gigabit Ethernet (GE) Interface
On the main control board, the SecPath V1000-A provides two 10/100/1000 Mbps
Ethernet interfaces: Ethernet 0 (right) and Ethernet 1 (left), each providing an optical
interface and an electrical interface (one in use at a time). The electrical interface uses
the RJ45 connector and the optical interface uses the Small Form-Factor Pluggable
(SFP) module.
Five 1000Base-FX SFP optical transceiver options are available for the SecPath
V1000-A: multi-mode short-haul (850 nm), single mode medium-haul (1310 nm), single
mode long-haul (1310 nm), single mode long-haul (1550 nm), and single mode
ultra-long haul (1550 nm). They all provide LC interfaces and are hot swappable.
The following table shows the Ethernet interface attributes of the SecPath V1000-A:

Table 1-5 Attributes of the GE electrical interfaces

Attribute
Connector
Interface type
Frame format
Operating mode
Connection to an ASCII terminal
Connection to a serial port on a local PC to run terminal emulation
program on the PC
Command Line Interface (CLI)
Attribute
RJ45
MDI/MDIX auto-sensing
Ethernet_II
Ethernet_SNAP
10/100/1000 Mbps auto-sensing
Full duplex/Half-duplex
(1000 Mbps and half-duplex cannot be used at the same time)
1-5
Chapter 1 Product Overview
Description
Description
RJ45
RS232
1200 – 115200 bps
Modem dial-up
Backup
Description