Figure 4-2 Setting Up A New Connection; Figure 4-3 Setting The Connection Port - H3C SecPath V1000-A Installation Manual

Installation Manual
H3C SecPath V1000-A Security Gateway

Figure 4-2 Setting up a new connection

Step 2: Enter the name of the new connection in the Name field and click <OK>. The
dialog box, as shown in Figure 4-3 pops up.
Step 3: Select the serial port to be used from the Connect Using dropdown menu. The
serial port must be the same port connected by the console cable.

Figure 4-3 Setting the connection port

Step 5: Click <OK>. The Port Settings tab, shown in Figure 4-4, appears and you can
set serial port parameters. Set the following parameters:
Baud rate = 9600
Databit = 8
Parity check = none
Stopbit = 1
Flow control = none
Chapter 4 Booting and Configuration
4-2