Chapter 6 Hardware Maintenance; Preparing Tools; Opening The Chassis Cover - H3C SecPath V1000-A Installation Manual

Installation Manual
H3C SecPath V1000-A Security Gateway

Chapter 6 Hardware Maintenance

6.1 Preparing Tools

Phillips screwdriver
Flat-blade screwdriver
ESD-preventive wrist strap
Static shielding bag
Note:
The tools are not provided with the security gateway, so you need to prepare them
yourself.

6.2 Opening the Chassis Cover

Step 1: Power down the security gateway and remove the power cords.
Step 2: Remove the interface cables from the front of the chassis, except for the
grounding wire.
Step 3: Place the security gateway on a flat table, with the rear forward. Use a Phillips
screwdriver to remove the two captive screws securing the cover at the rear of the
chassis.
Step 4: Undo the two captive screws securing the cover at each side of the chassis.
Step 5: Raise the cover to such a height that the edge of the cover is separated from the
bottom of the chassis.
Step 6: Pull the cover towards you until the tabs on the edge of the cover are separated
from the front panel. Put the cover away.
Chapter 6 Hardware Maintenance
6-1