Installing A Micro Sd Card; Connecting Interface Cables; Connecting An Ethernet Cable To A Copper Port - H3C MSR3610-X1 Installation Manual

Gigabit ethernet integrated service gateway

Hide thumbs Also See for MSR3610-X1:

Table of Contents

Figure 18 Installing the hard disk

Installing a micro SD card

No micro SD card is provided with the device. To use a micro SD card, purchase one yourself.

When you install a micro SD card, do not use excessive force to avoid damaging the micro SD card

slot. Insert the micro SD card into the slot along the guide rails.

Figure 19 Installing a micro SD card

Connect cables to the interfaces on the device before powering on the device. This section describes

the procedures for installing Ethernet interface cables.

Connect one end of the Ethernet cable to the copper port on the device. Connect the other end

of the cable to the copper port on the peer device.

The fixed copper ports on the device are MDI/MDIX autosensing. You can use straight-through

or crossover network cables to connect the ports.

Examine the port LED on the device to verify that the cable is connected correctly. For more

information about the LEDs, see

"Figure

20."

Table of Contents