Uploading/Downloading A Program/File Using Ftp - H3C SecPath V1000-A Installation Manual

Installation Manual
H3C SecPath V1000-A Security Gateway
Caution:
The upgrade should be performed through ETH0 on the security gateway.
The item "IP address of the server: [192.168.1.10]" must be set to the IP address of
the TFTP server connected to the Ethernet interface on the security gateway.
You are recommended to configure the IP address of the TFTP server network
interface and that of the ETH0 on the security gateway into the same network
segment.
Step 3: After you input the last parameter value, the system displays the following
message and returns to the Net Port Download Menu:
Saving config, please wait...OK!
Net Port Download Menu:
1:
2:
3:
Enter your choice(1-3): 2
Step 4: Select <2> to download the application program using TFTP. The system
displays the following message:
Starting the TFTP download...
..........................................................................
.......................
TFTP download completed...
File length = [03598640]
Writing program code to FLASH...
Please wait,it needs a long time .Please wait...
########################################################
Writing FLASH Success.
Press <ENTER> key to reboot the system .
The downloading is successful. Press <Enter> to reboot the system.

5.1.5 Uploading/Downloading a Program/File Using FTP

The security gateway can act as the FTP server. Any FTP clients (local or remote)
connected to the security gateway can update configuration files or upgrade
application/Boot ROM programs using FTP. A user can upload/download configuration
Change Net Parameter
Download From Net
Exit to Main Menu
Chapter 5 Software Maintenance
5-8