Connecting External Devices/Accessories To The Dlt-V4108 - Advantech DLoG DLT-V4108 Manual

Mechanical installation
14.3.

Connecting external devices/accessories to the DLT-V4108

The DLT-V4108 must be disconnected from the power supply:
− before external devices (e.g. scanner, keyboard) are connected or disconnected.
− and before the DLT-V4108 is connected to a network.
NOTICE: Physical damage
Observe the following when connecting/removing external devices:
−
Only use accessories that have been tested and approved by Advantech-DLoG for the
DLT-V4108.
−
The DLT-V4108 may not be connected to the power supply if external devices are being
connected/removed (not applicable for USB devices). Otherwise considerable damage could
be caused to both the DLT-V4108 and the peripheral devices.
−
Make sure that peripherals with their own power supply are either switched on at the same
time as the DLT-V4108 or after the start of the DLT-V4108.
−
Otherwise, you must ensure that a backflow from the external device to the DLT-V4108
cannot take place.
−
Only power up the DLT-V4108 when all devices have been connected and the DLT-V4108
has been closed correctly (remember the cable cover!). Otherwise, you may damage the
DLT-V4108.
Advantech-DLoG DLT-V4108 Manual, V01 Prelim 57 / 81