Mechanical Installation - Advantech DLoG DLT-V4108 Manual

14.

Mechanical installation

Requirement: The vehicle/installation location must be prepared (e.g. connection to the
ignition, correct voltage, etc.)
We recommend the following sequence for the installation:
− Determine a suitable mounting position for the DLT-V4108.
− Secure device mounting (e.g. RAM mount; optional).
− Connect external accessories to the DLT-V4108, if needed.
− Install an easily accessible disconnecting device to the DLT-V4108, such as a switch.
− Connection DLT-V4108 to the power supply.
− Seal cable bushings with cable grommets and dummy grommets.
− Close the DLT-V4108 with cable cover.
− Mount the DLT-V4108 on the installation location.
NOTICE: Physical damage
Installation environment without cooling air can overheat/damage the DLT-V4108.
The DLT-V4108 employs a passive cooling concept whereby the waste heat generated inside
the device is emitted from the surface of the housing. For this system to function properly,
sufficient fresh air circulation is required.
−
Never install the system in a closed environment where the cooling air is unable to
dissipate accumulated heat to the outside.
−
The maximum permissible ambient temperature for the entire system needs to be taken
into account for the specific application area.
Damage and scratching of the touchscreen without transport protective film.
The front display of the DLT-V4108 is protected during transport by a transparent film. This film
should remain on the front display during assembly to avoid damage to the front display surface.
−
Only remove the film after all of the installation work has been completed
52 / 81 DLT-V4108 Manual, V01 Prelim
Mechanical installation
Advantech-DLoG