Electronics Line iConnect User Manual page 56

HA Units
Home
Automation
Instant Arm
Keyfob
LAN IP Address
Limited Code
Log
Master Code
Message
Center
Non-Controlled
Code
One-Key
Arming
Panic Alarm
Part Arming
Partitioning
Perimeter
Arming
Medical
Emergency
PGM
Ready
Remote
Firmware
Update
Restore
50
H
Home Automation Units (abbr.). The lights and appliances in the
home that are controlled by the optional Home Automation feature.
An optional feature that enables the user to control electrical
appliances and lights via the Control System.
I
An arming method that cancels the entry delay after the system
has been Part or Perimeter armed.
K
Handheld wireless transmitters used to remotely control the system.
L
The address that your home router has assigned to the
Control System.
A user code that automatically expires 24 hours after it is
programmed.
See Event Log
M
The only user code with the ability to program other user codes. The
master code also has exclusive access to specific system functions.
An optional feature that enables users to record messages to be
played back by other users.
N
A user code that does not cause the system to notify the
monitoring service when used to arm or disarm. The system only
reports if the code is used to disarm after an alarm.
O
Arming the system without the need for a valid user code.
P
A user initiated event that alerts the monitoring service in the
event of an emergency.
An arming method that is designed to activate a certain section
of the premises.
Dividing the house into sections each of them armed and
disarmed independently.
An arming method that is designed to activate the sensors
protecting the doors and windows while enabling residents to
move freely on the premises.
A type of alarm that informs the monitoring service that the user
is in need of medical assistance.
Programmable output that is triggered according to specific
system status conditions, or by remote command sent via PSTN,
GSM, Ethernet, keyfob, keypad, or Remote Programmer.
R
The state in which all zones are closed and the system is ready
to be armed.
Control System's firmware update from a remote PC using WEB
communication.
Restore of the normal state when the trouble is repaired. For
example, if AC power is reconnected, an AC Loss Restore event
code is sent to the central station.
Appendix C: Glossary
iConnect User Manual