User Codes - Electronics Line iConnect User Manual

7. Advanced System Operation
2. Using the arrow buttons, scroll to the zone you want to bypass or unbypass.
3. Press to change the bypass status.
4. Press ; Save Changes? is displayed.
5. Press to confirm the changed bypass status.
To unbypass all zones:
1. From the Bypass Zones menu, select Unbypass All [22].
2. Press ; all zones are unbypassed
All bypassed zones will be automatically unbypassed when the system
is disarmed.
A fire zone cannot be bypassed.
7.3.

User Codes

The iConnect supports a variety of individual user codes. Each of these codes is four
digits long. Most system functions require you to enter a valid user code.
The ability to perform a function is defined by your user code's authorization level.
These authorization levels are pre‐defined for each code as explained below.
Code 1: Master Code
The master code is the highest user authorization level. With the master code, you can
edit all other user codes. Additionally, the master code grants access to the Event Log,
the Service menu and Home Automation Schedule programming. In partitioned
systems, the master code is always assigned to both partitions.
The default master code is 1234. Change this code immediately after the system
has been installed!
Codes 2-19: Controlled Codes
When you use a controlled user code for arming and disarming, the system notifies the
monitoring service.
Codes 20-25: Non-controlled Codes
Non‐controlled codes do not cause the system to send Arm/Disarm reports to the
monitoring service. The system sends a Disarm report only if you use this code to
disarm the system after an alarm occurrence.
Codes 26-27: Limited Codes
A limited code enables you to issue a code that is valid for one day only. This code
automatically expires 24 hours after it has been programmed.
Code 28: Duress Code
The duress code is designed for situations where you are being forced to operate the
system. This user code grants access to the selected operation, while sending a Duress
event message to the monitoring service.
iConnect User Manual
31