Electronics Line iConnect User Manual page 28

+ Perimeter Arm/Partitions 1 and 2 Arm, 128=Partition 1 Disarm,
129=Partition 2 Disarm, 200=Arm Status
The following example shows the format of an SMS command for disarming the system:
D
While the SMS Command Descriptor is optional, you must start the SMS
command with the # symbol for the system to accept the command. Donʹt use
ʺ#ʺ symbol within the descriptor text.
Arm Status Reply
On receiving an Arm Status request message (see command ʺ200ʺ above), the system
returns a status message to the sender. This message includes the system status and the
descriptor of the user or the device used to arm/disarm the system.
The following example shows an Arm Status Reply message reporting that the system
was fully armed by Master User.
F U L L
SMS Confirmation Message
After an SMS command is executed by the system, if programmed by your installer,
a confirmation message may be returned to your mobile phone. The following
example shows the confirmation message you receive for the sample command from
the previous section.
Remote Arming/Disarming via the Telephone
Using the Telecontrol feature, you can arm and disarm the system via the telephone. For
further information on the Telecontrol features, see p. 27, 6. Telecontrol.
Remote Arming/Disarming via WUAPP and WAP
You can arm and disarm the system remotely using the WUAPP (Web User Application)
and WAP – see Appendix B: Web User Application.
∗
Master code is required for the Arm Status command.
22
SMS Command
Descriptor
I S A R M
A R M E D -
D I
∗
)
User Code
# 1 2 3
M A S T E R
S A R M E D
3. Arming and Disarming
Command
4 1 2 0
U S E R
iConnect User Manual